Uogic AC10S Stylus Pen Instruction Manual - Manuals
Technology

Uogic AC10S Stylus Pen Instruction Manual – Manuals

Uogic AC10S Stylus Pen LOGO

uogic ac10s stylus

Uogic AC10S Stylus Pen IMAGE

operating instructions

  • To turn on the pen, press the power button for 1 second, the indicator will turn on. to turn off the stylus, press the power button for 2
  • charge the pen with a usb-c cable.
  • the pen will automatically turn off after 1 hour of use.
  • attach magnetically.
  • replace the tip (unscrew the old tip and screw on a new tip).

led indicator description

The pen will enter bluetooth pairing mode after power on. (blue indicator flashing) bluetooth pairing mode will last 30 seconds. when the pen is connected, the indicator stops flashing.

Reading: Uogic stylus pen how to connect

  • working: green light
  • charging: red light
  • full charged: green light
  • when the battery is low, the red indicator will blink 15 times, the pen will turn off automatically

bluetooth pairing instructions:

  • unlock ipad and go into settings.
  • tap bluetooth and turn it on.
  • turn on the stylus.
  • the stylus will appear below from other devices and touch the pen.

Note: If you want to connect the pen to another ipad, you must first disconnect the pen from the first ipad.

product parameter

See also: Klaviyo Shopify Integration: 4 Easy Steps

130mah

maximum battery output voltage

3.7v

temperature

0℃-35℃

inventory

See also: How to Communicate Telepathically with Animals – Animal Thoughts

instruction x1

All of the above data and information comes from the lab. may vary with environment or other factors.

fcc statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

See Also:  How to Install and Setup Azure AD Connect — LazyAdmin

note: this equipment has been tested and found to comply with the design requirements to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. however, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • reorient or relocate the receiving antenna.
  • increase the separation between the equipment and the receiver.
  • connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/tv technician for help.

The device has been evaluated to meet general RF exposure requirements. the device can be used in portable exposure conditions without restrictions.

See also: How to Connect MetaMask to OpenSea – DC

warranty card

documents / resources

Related Articles

Leave a Reply

Your email address will not be published.

Back to top button